Recent content by Bumpin-Thumper

  1. B

    Where to get resistors

    not gain....
  2. B

    Where to get resistors

    Polk momo 5.25 and an eclipse xa4000 (125wx4) and the xover is at -6db already. and why a bad idea, might I ask?
  3. B

    Where to get resistors

    My tweeters are too bright, I have done all I can. I can't find where to get any resistors so the bump up the resistance, to say 4.5ohm. TY
  4. B

    Resistors , where to get?

    My tweeters are too bright, I have done all I can. I can't find where to get any resistors so the bump up the resistance, to say 4.5ohm. TY
  5. B

    need some help fitting subs in my truck

    pass through box. your box sits in the bed, while your subs are in the cab. A hole needs to be cut through the divider. I believe these are fairly new, but I have seen them and heard of them done. You could put some **** big subs in
  6. B

    How to tame some tweets

    TY:thumbsup:
  7. B

    1000 rms @ 2 ohms

    alpine mrd-m1005
  8. B

    RE SX 15" vs Alpine Type R 15"

    I have a 15-r in a sealed spec. enclosure. feeding it over 1000w , and it sounds great, gets loud and sounds clear, good sound in my opinion. Couldn't be happier
  9. B

    Polk SR's.......56K NO!

    I was planning on getting 2 of these 12s, in a sealed spec. enclosure powered by a kicker sx1250-1 in a 1ohm load. Would this be recommended? sound great?
  10. B

    How to tame some tweets

    I can't seem to get my tweeters to not be sharp at loud volumes. It just hurts the ears with (S) and (CH) vocals, and other random high notes. They can go louder, but those harsh notes keep me from turning them up. I have polk momo 5-1/4 comps, powered by an eclipse xa-4000 (125w X4) I have...
  11. B

    2007 Ford Focus power wire.

    I have an 07 Fusion, there was a white piece of plastic above the gas/brake pedal. A round something, that was more than big enough for 0 guage. I drilled threw it from under the hood,(goes through the firewall) then I had to run all the wires under the floor carpet. Hope this helps
  12. B

    1 typex 12 and 2 typer

    sarcasim? or you seriouse? cuz im a newb
  13. B

    1 typex 12 and 2 typer

    I want to put 3 12s in the trunk to bump. If i ran 2 typer recieving 500w a piece and then 1 type-x recieving 1000w will it work? just a dumb question but i need some help. or if you have any suggestions and a (3) 12" setup just post away. thaks
  14. B

    2nd battery vs HO alt.

    whats carckin. I drive a 99 vw passat. have an alpine mrd1005 running a type-r15" wired for 2 ohms. and I have a mrd somethin pushin 75w to each component. with a stock alt and a decent battery I can only get about 13.5v on each amp. (idle and driving) I want both amps to be @ 14.4 volts. if...
  15. B

    need 2000@1ohm for (2)12" type X

    like title says. having some trouble deciding thinking a picasso2000d 2000rms@1ohm thanks
Top