Recent content by face_reality

I have two 12 inch Alpines S pushing 500 watts each wondering what the amp settings should be? There in a sealed box. Has sub sonic, bass eq, low pass, phase, level.. Not sure what these settings should be..

Mine will go in the stow and go are check attachments

Ok gotcha, I know what port and sealed boxes are, mine are going to be sealed and pushing 500 rms per sub, the stow and go is like under the floor of the van if your familiar with that, it's like a cut out so the seats can lay completely flat out of the way.. There is like panels that cover the...

No clue what that means

No driver side and passenger side subs facing straight up

Lol your going to laugh on what I'm putting them in but I'm putting them in a dodge caravan and they have stow and go seats so I'm going to put them on each side of the stow and go.

Yeah I just contacted a few people on here

Sws-10d4

Sorry forgot to mention each sub will be in its own box

I'm getting some alpine's SWS-10D4 running at 500 rms 4ohm dual voice coils I'm thinking, the max demension for a box would be 20 x 20 x 8 inches deep it will be a perfectly square box with sub facing upwards, so I'm asking if that's the max demensions would that be enough to support those subs...

2 alpine 10inch

After all the yay and nays about PPI I went with PG hope it was a good choice got a good deal on it I think.

Hifonics? Had one before it seemed to be decent?

It'll be dual voice coil 4ohm I'm thinking haven't ordered them yet.. Thinking 4 though so I can drop to 1ohm

Looking at getting 2 alpine 10's running at 500 rms each , looking for a good amp I was leaning towards PPI but wondering what else is out there that may be better? Less then $300