Recent content by helotaxi

Some people don't understand the difference between polyfil and batting and when to use each.

I use uncut Simple Green for stripping paint off parts. Works great.

Sink the Hurricane nuts into their holes and then use a Dremel with a grinding bit to shave the flange.

Not an appreciable amount. Goes alot quicker when you use the right tool, like a torch. The best way is to quit being cheap and buy the right length of wire.

Winner!

Use protection...

Get a machine type screw and use these. Much better than any screw that has to bite into the wood.

orly?

A shielded RCA is surrounded by "ground" in all directions.

The Sundowns were built to be midbasses, not midranges. They're based on pro drivers but were tweaked for the car to work optimally in and IB config and to provide good midbass. Gave up a bit of efficiency to make this happen.

The 45s in the corners are more geared toward high power, high SPL setups where anything that can be done to eliminate turbulence might increase SPL. Not to an audible degree, but 0.1dB can be the difference between 1st and 1st place loser. In you case, won't make a bit of difference.

You had something going on there other than interference from the wireless signal. There is a ton of RF energy from cell phones coursing through your car all the time, whether your phone is ringing or not.

An RMS meter actually uses sampling to determine the RMS voltage instead of taking the peak and multiplying by .707. This accounts for different waveforms.

Odd. I have a pair of them in my garage right now. I guess I'm imagining that.

Yep. Those are them. They're going under the rear seat in my F-150 SuperCrew.