Recent content by nkrell11

SPL is a fickle beast, I could do the things you mentioned and lose on the meter. I'm going to do a stripper pole for sure I don't know if I want to add more deadener yet or not. The most notable build in my opinions for the 2 18 160 is Ray Pimley did a 64 or so with 2 18's in a 2 door Cherokee...

There's a show in Muskegon on the 15th you should come out, I'll be there.   ---------- Post added at 11:20 AM ---------- Previous post was at 11:20 AM ----------   Trying to upload some videos that Alec sent me from his snapchat story I have some stories I would like to try and splice...

I certainly am happy the compliments I got about how clean it was made me just as happy as peoples reactions to how loud it was. I'm not the least bit disappointed, some off season tweaks could bring about some improvement.

Alright so I kind of finished the Jeep enough to go to a show this weekend. I got everything fused and my voltage would not charge where it needed to be. I think it's because I'm trying to run two alts off of one regulator. So for the show I elected to run down an alt, last night I ordered...

That and I'd rather do it once than twice considering how time consuming it was.

Thanks I've never done doors before ever. This is my first build doing any fiberglass work at all.

I used carriage bolts in place of the plastic clips to hold the bottom of the panel to the door. I wanted to do threaded rod but most of the places I could go through theres a void or something behind the door skin. Alright drumroll please.... Finished and installed.I also put more deadener...

After everything was good and hard it was time for filler and sanding...lots of sanding. After all that it was time to prime/paint/bedliner. Afterwards I cut out the backs using a jigsaw and a cutoff wheel. Made some grills using the insides of my cutouts, they'd have turned out...

Alright so my door panels are installed and everything in them is wired up. Overall I'm happy with how the doors came out for this being a first try at ever making any. I'll try and explain the pictures as well as I can. First I made the panel to hold everything and cut out all the holes, which...

Well I'm still working on the doors I can only do so much sanding before I get sick of it, I did get my VC1 holder done I think it turned out great. Tried to capture a picture of it lit up but it was so bright or something my phone wouldn't pick up the numbers. I also did some more sanding and...

Just can't see all 6 from that angle. The material its welded to isn't really strong enough to drill and tap and there was no way to get nuts on the back side. I think they will suffice how the two types compare I don't know.

Alright so I've been slacking on the updates a little bit. Aside from working on my doors I've been modifying my ash tray to hold my voice coil temp sensor display. Getting sick of fiberglass to be honest but you gotta do it. A little filler and some sanding and this thing will be ready for...

Lets see here I put on a sticker, not really a huge fan of sticker bombing the outside of vehicles not sure if I'll use more on the insides like the one I used or not. Welded on some bolts for frame grounds as there wasn't any good ones. Attached wires to said bolts to do the big 3 or...

Ok so I guess it's been too long since I've updated this. Anyhow state finals was this last weekend and I didn't make it lol, surprise surprise. So lets see I got my alts back from mechman really fast it was like two days and they were on their way back I think it was $280 for repairs. I had the...

You know that thought had crossed my mind and I knew just the thing to grab from work but I totally forgot about it, I really just wanted to get out of there today. No it won't play until it's done want to save all of my disappointment for the end.