Recent content by Ramrod

My Fuse going into my Amp was a little loose on one end. I tightened it and I think it might be good now. Guessing the Bass was knocking the connection vibrate and loose power. The Red light isn't coming on now. So that's good. The Blue stays on and steady now. Not sure if it's 100% yet thou...

Everything is maybe a 1yr old. The Equip. is listed in my sig.. It's to late to test anything while playing. I went around checked most the connections. Seems good there. Checked the Resting Voltage at both Batteries and Amp. All where 12.49v. I turned my Gain done a little. On my drive into...

I haven't touched my set up for a months and everything as been running smooth. Till tonight on my way into work. I don't blast it much at all. My American Bass 4480.1D I think is clipping now. I noticed my Bass tonight ****** and sounds like a burst or clip of bass. The Amp isn't hot and...

Ok starting to really really like this set up now. Went over to a buddies house to drop something off. Went to show him my set up and told him my thoughts on it. Well he adjusted my amp and WOW did it make a difference. Main thing was my freq. was set to high. Before it seemed like Songs I knew...

At 1/2 it wouldn't Barely move the Sub. I'll look into those. I'll have to figure a way to hide them in my install. Whats the difference between that and a CAP or BATCAP..

I thought I wouldn't have this issue this time around... Mechman Alt. 240a Odyssey PC1350 AGM for Main XS Power XP750 BIG 3 done American Bass XR12 - wired to 1 Ohm American Bass 4480.1 - gain 3/4

Bad news is I've got to pull my Subwoofer out and clean the Window. The **** Blue LEDs shows everything...I might be able to reach it through the Port. I haven't silicone it in yet.

Got all the LED's ran and all that is left in the trunk to do is the false wall over the Amp. I still have access to my Spare tire too. Had to make some O-Rings here to keep them apart. This is one thing American Bass needs to change. The POS/NEG are right by each other. Would be nice of...

I do, I ran 00 welding wire on top of the factories 0 from the Alt to Battery with two 250a Fuses in line. The gain is 3/4 the way up at the Amp and 1/2 on the remote knob. Couldn't even get the Sub to move till it was 1/2 way...

Ok All Hooked up and Bumping... Even with everything I have. 2nd Battery, 2x Zero Gauge from 240a Mechman to Main AGM. Big 3 Done with Zero gauge as well. I'm still getting flicker from my lights...

Getting there...

Slowly getting work done, But it's getting there. Will be getting a lot of work done this week as I need to get my back seat back in...lol Amp Mount is installed.. Now the Amp mounted up.. I will make a Wall with a Window to hide everything but the amp. Wire ran for 2nd Battery and Amp...

For a 2010 Dodge Charger ported through rear Deck. Perfect fit.

New 2nd Battery mount I just made.. The first just felt and didn't look as good as I hoped.. Thoughts? I'm not to good with wood and never stained anything before, but I'm proud of myself.

Gerty Mac