Recent content by Stephenpvand

Ill record it when one of them blows up n shits itself for you haha

Alright thanks my 4 channel rockville amp isnt being pushed too hard rn like 70% gain but its got alot left in it when i turn it up. but when I upgrade my sub setup i will be pushing that amp as much as the sub can handle haha but ill just wait on upgrading the wire for now thanks for the input...

So if your saying that I wont pull above 60 amps anyways with those 2 amps anyways theres no need to upgrade to 0gauge?

So the wire came with the 60amp fuse but to run both amplifiers properly I believe I would need around 70 amps so would it be unsafe to upgrade the fuse becuase the wire itself cant handle more than 60 amps anyways?

I can only fit 1 10 I have a 12 in in a 1.5 cu in box rn that sounds decent but defiantly need more so i want to use the same box and just refit the top board to hold a 10 and the box takes up almost more room than i want it to so i cant go any larger with the box but ill take a look at the amp...

What fuse would you recommend for running both because right now it has a 60amp fuse should i upgrade it to say 80-100? Also thanks for the ohm knowledge when I asked skar about which amp to run on the sdr10 they recommended the d4 sub and 750 amp so I was just going with their knowledge but...

Its a The power cable is less than 15 ft long but is cca. and with both of those amps the amperage would be about 75-80 at max power but my rxa-f1 is only running at about half power so im guessing its total draw with the skar amp would be about 60amps on the 4 gauge wire. So would that be ok...

I currently have 2 amps in my truck one is done correctly has 4 gauge wiring from battery and is a 1600w max power my 4 door speakers (rockville rxa-f1). The other is a cheap ass 600 watt max running off of some random power cable powering my sub. I want to upgrade my sub and amp to keep up with...