Recent content by Teacher Denis

Hello Car Audio people: My Pioneer cd player keeps shutting off when I go over almost any small bump. All the wires seem fine, good connections. But the stereo does Not forget it’s presets or settings. Also the connected pre-amp would shut off as well. I figured the problem was in the CD player...

Should I line my ported subwoofer box?? It has 2 12'' Pioneer subs, 1 rectangular port, 1.5 cu.ft. per sub. Will lining the inside of the box help? How? With what? THANKS

HI Buck. I will check the ac voltage on the rca cables coming out of the Clarion Pre-Amp EQ. They should be 8 volts according to the manual. Even if they are less volts, I think I should be able to get more than 15 volts on the speaker output wires to the subs. My calculations say I aim for 44...

My pioneer head unit has a 2 volt output that goes into my clarion 7 band pre-amp EQ that has an 8 volt output (to the sub amp) All settings on my headunit and EQ are at zero / flat.

My pioneer head unit has a 2 volt output that goes into my clarion 7 band pre-amp EQ that has an 8 volt output (to the sub amp) All EQ settings and headunit settings are at zero.

My pioneer head unit has a 2 volt output that goes into my clarion 7 band pre-amp EQ that has an 8 volt output (to the sum amp)

Hello. I am setting up the gain on my Autotek M4000 amp. (used for 2 12'' subs in parallel) I ran a 50 hz tone at 80% volume (Pioneer head unit). The highest voltage reading I could get was 15 volts. That is with the gain tuned all the way up (reading 0.2 Volts on the amp). I should set the...

Hello. I am setting up the gain on my Autotek M4000 amp. (used for 2 12'' subs in parallel) I ran a 50 hz tone at 80% volume (Pioneer head unit). The highest voltage reading I could get was 15 volts. That is with the gain tuned all the way up (reading 0.2 Volts on the amp). I should set the...