Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
And suddenly, the bass stops.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="deymious" data-source="post: 8161178" data-attributes="member: 656740"><p>hey guys I need your advice once again. I used a multimeter to see that it was in fact my amp that was done (it's not sending out any power to my subs). What I need now is to figure out how to set the gain on my next amp to make sure that its not putting out too much power to blow.</p><p></p><p>I have two kicker cvr's 12 inch with 400 watt rms each at dual 4 ohm. So together, its 800 watt rms but idk how you add the ohms together. I was hoping on getting the kenwood kac_9105d because I'm most familiar with that series of amps and to wire the subs in parallel, but can i make it so the amp does not go over XX amount of voltage so that it doesnt blow? If i wire the subs in parallel to the amp, will that be enough power for the subs and not too much to kill the amp? so regardless of how high i try to put the volume on my headunit, the amp won't blow because it cant physically go higher? just wanted to see if this was possible and your opinion of the new kenwood amp.</p><p></p><p>thanks a lot, really appreciate all of the help guys!</p></blockquote><p></p>
[QUOTE="deymious, post: 8161178, member: 656740"] hey guys I need your advice once again. I used a multimeter to see that it was in fact my amp that was done (it's not sending out any power to my subs). What I need now is to figure out how to set the gain on my next amp to make sure that its not putting out too much power to blow. I have two kicker cvr's 12 inch with 400 watt rms each at dual 4 ohm. So together, its 800 watt rms but idk how you add the ohms together. I was hoping on getting the kenwood kac_9105d because I'm most familiar with that series of amps and to wire the subs in parallel, but can i make it so the amp does not go over XX amount of voltage so that it doesnt blow? If i wire the subs in parallel to the amp, will that be enough power for the subs and not too much to kill the amp? so regardless of how high i try to put the volume on my headunit, the amp won't blow because it cant physically go higher? just wanted to see if this was possible and your opinion of the new kenwood amp. thanks a lot, really appreciate all of the help guys! [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
And suddenly, the bass stops.
Top
Menu
Home
Refresh