Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Custom Box for Truck; Size constraints - Help & Tips needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Doxquzme" data-source="post: 8867582" data-attributes="member: 689267"><p>Sorry, should have clarified, 3 cu ft gross is optimal from what I can see. Dual 4 inch flared ports 20" long. A single center-ish brace can act as both a brace and port support if mounted so that the two ports terminate at the braces end (don't want to the brace to extend the ports length) so through and flush with the brace.</p><p></p><p>[ATTACH=full]55788[/ATTACH]</p><p></p><p>Slightly to one side where the end of the ports would sit in the brace, completely around or half as pictured. Hole in the center is optional on the half-length brace, one on each side if full brace used.</p></blockquote><p></p>
[QUOTE="Doxquzme, post: 8867582, member: 689267"] Sorry, should have clarified, 3 cu ft gross is optimal from what I can see. Dual 4 inch flared ports 20" long. A single center-ish brace can act as both a brace and port support if mounted so that the two ports terminate at the braces end (don't want to the brace to extend the ports length) so through and flush with the brace. [ATTACH type="full" alt="1704164108506.png"]55788[/ATTACH] Slightly to one side where the end of the ports would sit in the brace, completely around or half as pictured. Hole in the center is optional on the half-length brace, one on each side if full brace used. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Custom Box for Truck; Size constraints - Help & Tips needed
Top
Menu
Home
Refresh