Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Custom Box for Truck; Size constraints - Help & Tips needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Memnoch" data-source="post: 8867726" data-attributes="member: 690593"><p>thank you that clears it up quite nicely. Looking at the slight wedge box he is building (sealed for each sub) which he has already cut the pieces for, It's looking at roughly 1.31 cu ft per sub side. Silly question, how do you wire the 2 subs together if they are sealed in their own boxes respectively. Do you just connect them at terminals on the outside of the box and then run to the amp? The final wiring diagram is the one you suggest for these subs/amp combo?</p><p></p><p>Also as I stated, when testing the speaker it was reading at 2 OHM, so does that mean that the speakers may be bad or just not rated to what they should be?</p><p></p><p></p><p>Side note, I went to the garage, measured all of his cuts and built it in sketchup, nothing lines up lol...he's going to be doing some more cutting before he's able to piece that thing together.</p></blockquote><p></p>
[QUOTE="Memnoch, post: 8867726, member: 690593"] thank you that clears it up quite nicely. Looking at the slight wedge box he is building (sealed for each sub) which he has already cut the pieces for, It's looking at roughly 1.31 cu ft per sub side. Silly question, how do you wire the 2 subs together if they are sealed in their own boxes respectively. Do you just connect them at terminals on the outside of the box and then run to the amp? The final wiring diagram is the one you suggest for these subs/amp combo? Also as I stated, when testing the speaker it was reading at 2 OHM, so does that mean that the speakers may be bad or just not rated to what they should be? Side note, I went to the garage, measured all of his cuts and built it in sketchup, nothing lines up lol...he's going to be doing some more cutting before he's able to piece that thing together. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Custom Box for Truck; Size constraints - Help & Tips needed
Top
Menu
Home
Refresh