Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Enclosure Design & Construction
Fi BL18 Ported Box Design Help
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="SirPudge" data-source="post: 8259108" data-attributes="member: 660852"><p>Would this work for a box design? That is max height in the "front of car area of trunk" in pink, trunk lip in blue, and preferred "tail light area of trunk"height in green(wanting woofer and port on same plane as per Fi's recommendation by their support guru.)</p><p></p><p>[ATTACH]26547951[/ATTACH]</p><p></p><p>The face(black) will have to be wedged to achieve 19. I have 18-18.5 height to work with at that part of the trunk. Sub OD is 18.5. Or I could do woofer on top. In that case, I'd probably go rectangle for ease and fine tune my cuts.</p><p></p><p>Could someone tell me if this would work and help with calculations? I have no idea what type of math I would do for this. I have so far only used RE. Thanks</p></blockquote><p></p>
[QUOTE="SirPudge, post: 8259108, member: 660852"] Would this work for a box design? That is max height in the "front of car area of trunk" in pink, trunk lip in blue, and preferred "tail light area of trunk"height in green(wanting woofer and port on same plane as per Fi's recommendation by their support guru.) [ATTACH=CONFIG]26547951[/ATTACH] The face(black) will have to be wedged to achieve 19. I have 18-18.5 height to work with at that part of the trunk. Sub OD is 18.5. Or I could do woofer on top. In that case, I'd probably go rectangle for ease and fine tune my cuts. Could someone tell me if this would work and help with calculations? I have no idea what type of math I would do for this. I have so far only used RE. Thanks [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Enclosure Design & Construction
Fi BL18 Ported Box Design Help
Top
Menu
Home
Refresh