Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
General Car Audio
First time LOC user and looking for suggestions on tapping into the factory wires!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="fatboytyler" data-source="post: 8639387" data-attributes="member: 658624"><p>My new power and speaker cables come in tomorrow then I'm going to begin my actual install in my new truck, but I'm keeping the factory head unit. I've got 95% of the build already planned, but am looking for suggestions on the best place to tap into the factory wiring.</p><p></p><p>My original plan was just to tap into the factory harness at the head unit, running the cables back to my Lc7i. But, would be it easier/advisable to just tap into them right before they go into the door grommet so I don't even have to worry about getting behind the head unit?</p></blockquote><p></p>
[QUOTE="fatboytyler, post: 8639387, member: 658624"] My new power and speaker cables come in tomorrow then I'm going to begin my actual install in my new truck, but I'm keeping the factory head unit. I've got 95% of the build already planned, but am looking for suggestions on the best place to tap into the factory wiring. My original plan was just to tap into the factory harness at the head unit, running the cables back to my Lc7i. But, would be it easier/advisable to just tap into them right before they go into the door grommet so I don't even have to worry about getting behind the head unit? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
General Car Audio
First time LOC user and looking for suggestions on tapping into the factory wires!
Top
Menu
Home
Refresh