Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Discussion
Car Audio Build Logs
Ford ranger extended cab semi-wall build
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="bunkrd you" data-source="post: 7079898" data-attributes="member: 626734"><p>built a battery rack for my yellow top d31 to sit on top of my deka. I tripple grouded my deka and used the machined posts as a d block for grounds and have two grounds to my seats that are grounded through to the chassis, two to a rear seat belt mount which also goes through to the chassis and two grounds up front to the chassis, and engine block. 4/6 of these grounds are in 2/0 and the rest in 1/0. I just ordered a us md3d and it should get pretty loud in my new box. I had a md1d previously and liked it hence why I bought the md3d.</p><p></p><p>Also decided on polk components and a kenwood head unit.</p><p></p><p>Polk Audio MM6501 - 6-1/2" Component Speakers System - Sonic Electronix</p><p></p><p>Kenwood eXcelon KDC-X794 (kdcx794) CD/MP3 Car Stereo Receiver</p><p></p><p>Can I bridge the components which are 2.7 ohms into the alpine mrp220? or would that ohm load be unstable?</p></blockquote><p></p>
[QUOTE="bunkrd you, post: 7079898, member: 626734"] built a battery rack for my yellow top d31 to sit on top of my deka. I tripple grouded my deka and used the machined posts as a d block for grounds and have two grounds to my seats that are grounded through to the chassis, two to a rear seat belt mount which also goes through to the chassis and two grounds up front to the chassis, and engine block. 4/6 of these grounds are in 2/0 and the rest in 1/0. I just ordered a us md3d and it should get pretty loud in my new box. I had a md1d previously and liked it hence why I bought the md3d. Also decided on polk components and a kenwood head unit. Polk Audio MM6501 - 6-1/2" Component Speakers System - Sonic Electronix Kenwood eXcelon KDC-X794 (kdcx794) CD/MP3 Car Stereo Receiver Can I bridge the components which are 2.7 ohms into the alpine mrp220? or would that ohm load be unstable? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Discussion
Car Audio Build Logs
Ford ranger extended cab semi-wall build
Top
Menu
Home
Refresh