Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Speakers
Hertz mille mlk 2tw
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="Fast-N-Loud" data-source="post: 8511610" data-attributes="member: 663322"><p>I just purchased a set of Hertz MLK 2TW components. It includes Hertz ML1600 drivers and ML280 tweeters and the crossovers. I will be running them off my Kenwood ZR900-5 amp. The amp is currently at 60rms to all four corners and 600rms to the two JL W3 subs in the rear. My question is the Hertz website states 150rms but I'm not sure if that means 150rms per side or 150rms total for both driver and passanger together. I can bridge my amp and run 150rms per side if needed. I have heard other people say these components need power. What do you guys think. run them at 150rms each or 60rma each. Side note, what size speaker wire should I use on them. Thanks for any help guys.</p></blockquote><p></p>
[QUOTE="Fast-N-Loud, post: 8511610, member: 663322"] I just purchased a set of Hertz MLK 2TW components. It includes Hertz ML1600 drivers and ML280 tweeters and the crossovers. I will be running them off my Kenwood ZR900-5 amp. The amp is currently at 60rms to all four corners and 600rms to the two JL W3 subs in the rear. My question is the Hertz website states 150rms but I'm not sure if that means 150rms per side or 150rms total for both driver and passanger together. I can bridge my amp and run 150rms per side if needed. I have heard other people say these components need power. What do you guys think. run them at 150rms each or 60rma each. Side note, what size speaker wire should I use on them. Thanks for any help guys. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Speakers
Hertz mille mlk 2tw
Top
Menu
Home
Refresh