Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
JL Audio e1800d settigns for 2 Alpien Type R's 1243d
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="ERIKCABRERA" data-source="post: 7262308" data-attributes="member: 631485"><p>i have 2 alpine type R'S (New Models) and i wanted to know whats the right way to set them inside, i think its positive to positive, then negative to negative, finally use the outside positive and negative for the speaker wires. I think this is for it to be set at 4 ohms each and the amp will give off 2ohm of 1100W. Now if this is correct (please verify this) now what do i set on the amp like LP Filter Freq. (Hz), Input Sensitivity, LP Filter Off,12db,24db? and obviously i leave bass boost on. Let me know thanks.</p></blockquote><p></p>
[QUOTE="ERIKCABRERA, post: 7262308, member: 631485"] i have 2 alpine type R'S (New Models) and i wanted to know whats the right way to set them inside, i think its positive to positive, then negative to negative, finally use the outside positive and negative for the speaker wires. I think this is for it to be set at 4 ohms each and the amp will give off 2ohm of 1100W. Now if this is correct (please verify this) now what do i set on the amp like LP Filter Freq. (Hz), Input Sensitivity, LP Filter Off,12db,24db? and obviously i leave bass boost on. Let me know thanks. [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
JL Audio e1800d settigns for 2 Alpien Type R's 1243d
Top
Menu
Home
Refresh