hu problems

re connect ur rca's at both the deck and amp..

check wires @ speakers on both left sides

finally, check wires @ hu for those two sides..

u may need ot cut old wires off and reconnect @ a new point

 
I don't have it hooked up to an amp yet. I have all of my "stuff" (new speakers) and an amp and am getting ready to put it all together but don't want to do that if the hu is unfixable. :stuck:

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

How old is the unit? My Pioneer died last month (manufacture date April 2021). Apparently they had component supply problems after Covid and...
3
1K
I suspect it's an ignition problem rather than a transmission problem. Start with the basics: plugs, wires, coils, check engine codes. Does the...
4
1K
Will you post a picture if the LC2i as it is wired. How did you set the output gains of the LC2i? What is the max voltage gain input on the amplifier?
1
1K
I feel like its a bad set(Low tier set) of RCAs myself. I use Stinger Zero Noise and 4000-8000 series without any issues. Dayton makes a nice set...
6
2K

About this thread

plyhammer

10+ year member
Senior VIP Member
Thread starter
plyhammer
Joined
Location
ohio
Start date
Participants
Who Replied
Replies
4
Views
408
Last reply date
Last reply from
plyhammer
IMG_1914.jpeg

AnthonyO

    Sep 7, 2024
  • 0
  • 0
IMG_1913.jpeg

AnthonyO

    Sep 7, 2024
  • 0
  • 0

New threads

Top