cocoleveo7686
10+ year member
CarAudio.com Elite
i have a friend who has 2 12 Jl audio w6's the old version, they are dual 6 ohms, and my question is, i have a ma audio hk897 amp i was going to sell him and here are the specs
1200W 2 Channel Amplifier
300W x 2 RMS @ 4 Ohm Stereo
500W x 2 RMS @ 2 Ohm Stereo
1200W x 1 RMS @ 4 Ohm Mono
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Variable High Pass & Low Pass Filters (40 - 250Hz)
Platinum Plated Block Terminals
Fully Regulated Power Supply
Stainless Steel Finish Heat sink
0-18dB Variable Bass Boost
Quiet Fan Cooling System
Full Mosfet Circuitry
2 Ohm Stereo Stable
THD:
is there anyway that he can wire those subs to get good power out of this amp?
1200W 2 Channel Amplifier
300W x 2 RMS @ 4 Ohm Stereo
500W x 2 RMS @ 2 Ohm Stereo
1200W x 1 RMS @ 4 Ohm Mono
Thermal, Short & Overload Protection Circuitry
Platinum Plated Screw Type RCA Jacks
Double Sided Black Epoxy PCB Board
Variable High Pass & Low Pass Filters (40 - 250Hz)
Platinum Plated Block Terminals
Fully Regulated Power Supply
Stainless Steel Finish Heat sink
0-18dB Variable Bass Boost
Quiet Fan Cooling System
Full Mosfet Circuitry
2 Ohm Stereo Stable
THD:
is there anyway that he can wire those subs to get good power out of this amp?