First of all, let me state that this will be a looong build thread. Most pieces in this build will be done piece by piece. Some things may be ordered together when money allows, but for now, it's piece by piece.
This build is going to be done right, and right the 1st time. No going back and adding the big three to make my lights not dim or stupid ish like that.
The scheduled plans as of now for the way the build will unfold is as follows.
1. Upgrade cranking battery.
2. Upgrade Alternator/Big 3.
3. Two runs of 1/0 power/ground.
3. Gut car, and sound deaden.
4. Build Carputer.
5. Begin buying woofers, and amps, and speakers.
Basic Rundown of what will be going into the car are.
1 Kinetik 1400, 2 Kinetic 2000's, & a 200a Alternator.
Second skin entire car. Floor, dash, doors, roof, trunk, & trunk lid, everything.
Run the 2 runs of 1/0 power/ground.
Complete Carputer
2 IA 20.1 @ .5 load per woofer. 2 Fi Audio 15BTL dual 1ohm all options, Custom enclosure @ around 8cuf after sub/port displacement. Isolating the trunk from the cabin with front firing subs, and port.
The mids/highs are undecided upon at this time, but whatever it is will be powered by a Kicker KX800.2 running at 2ohms, on 4 sets of components.
I am open to any suggestions anyone may have at this time.
As of today, the very first thing on the list has been completed. The new battery, So without further adieu, here is the 1st phase in "Project Civic Go Boom".
Kinetik 1400 is in. Note that the terminals on there now are just temporary as the stock ones were too large to fit over the posts. At the next phase of this project which is Alt/Big 3, these terminals will be changed.
This build is going to be done right, and right the 1st time. No going back and adding the big three to make my lights not dim or stupid ish like that.
The scheduled plans as of now for the way the build will unfold is as follows.
1. Upgrade cranking battery.
2. Upgrade Alternator/Big 3.
3. Two runs of 1/0 power/ground.
3. Gut car, and sound deaden.
4. Build Carputer.
5. Begin buying woofers, and amps, and speakers.
Basic Rundown of what will be going into the car are.
1 Kinetik 1400, 2 Kinetic 2000's, & a 200a Alternator.
Second skin entire car. Floor, dash, doors, roof, trunk, & trunk lid, everything.
Run the 2 runs of 1/0 power/ground.
Complete Carputer
2 IA 20.1 @ .5 load per woofer. 2 Fi Audio 15BTL dual 1ohm all options, Custom enclosure @ around 8cuf after sub/port displacement. Isolating the trunk from the cabin with front firing subs, and port.
The mids/highs are undecided upon at this time, but whatever it is will be powered by a Kicker KX800.2 running at 2ohms, on 4 sets of components.
I am open to any suggestions anyone may have at this time.
As of today, the very first thing on the list has been completed. The new battery, So without further adieu, here is the 1st phase in "Project Civic Go Boom".
Kinetik 1400 is in. Note that the terminals on there now are just temporary as the stock ones were too large to fit over the posts. At the next phase of this project which is Alt/Big 3, these terminals will be changed.
