kenpo1441
Junior Member
I am getting ready to install my system in a 2000 Explorer. I am using 0 gauge Stinger power wire, 1 farad Stinger capacitor, Kenwood Excelon X-401 and X-501 amplifiers. Just wondering what battery I should get?
Activity
No one is currently typing a reply...
Similar threads
If I do find out I have an over charge problem what can I do to fix that? I’m gonna install my Honda hack back on the radio and it’ll show me the...
- Started by kushybaker
- Wiring, Electrical & Installation
136 amp would be good. There are higher voltage regulators for the jeeps.
- Started by Blackout67
- Wiring, Electrical & Installation
For some extra peace of mind, you could do a big-3 upgrade with the same 4 guage ofc wire.
- Started by zoltman1991
- General Car Audio
Disconnect the amp for a day or two, then connect it back up. If it stops draining when unplugged then drains again, take it back and have them...
- Started by zoltman1991
- Wiring, Electrical & Installation
On your van, when you connected the radio, was it a double din or single din? And e the radio sitting in the 2005 Chevy Van, is it nicely fit or...
- Started by HandsomeSteve
- Wiring, Electrical & Installation 2
About this thread
New threads
-
Battery smells funnyI installed a XS power super bank (Capacitors) to my setup...
- Started by kushybaker
- Replies: 6
-
FEATURED How to maximize my new setup?I bought a ported sub box for my 07 f250 crew cab with .7...- Started by Henry H.
- Replies: 4
-
What Head Unit.???Good day I need some help with "What head Unit to choose" I...
- Started by Mazzy
- Replies: 2
-
RCA Y-cables causing a bad humNew member here with a question that's baffling me... I have...
- Started by ultm8z
- Replies: 2
-
