Recent content by dmuney

Yes i know that's what i was planning on. Unfortunately the rvca's are a little difficult to gain access to. My other thought was to wrap a wire around rca shield on back of head unit and attach to ground which may take care of it also.

Hey everybody Its been a while since i posted. My new system starts with a Pioneer ???930bt multimedia headunit, which feeds a PPI DEQ31 EQ then off to a PPI FRX456 to a PPI PC4800.2 for my front stage with some cheap boss audio components. For my sub output the FRX feeds a Sundown SCV6000D...

ok ill try and keep it simple how long does my port need to be to be tuned to 20hz

if you wall off your trunk then hell yes portyour box through the rear deck. i even recommend adding a vent of some kind even if its not walled. i've had several trunk builds and on cars where you can either remove or fold down the back seat. you notice a huge gain in output...

If you want a good sealed wall by yourself a but load of expanding foam and fill in ever nook and cranny it works excellent I used 20+ in my civic wall build I'd say you'll need 50 cans watch out its messy also kills rattles and vibration just fill everything behind your wall

i say lets buy a mid length bus we can put about 200k of power and 64 18 team sundowns, 16 370a alts about 1000 ft 1/0 cable and say 200 400 sheets mdf that would probably bump nasty loud

because we can't afford to build one ourselves

yea he may be fine but remember my 2 sa-12's in 4cuft tuned to 28hz would only play down to 26hz with any kind of authority anything lower and no output only movement although it may wind up working out for him also there is just way to many factors to account for

if you want to play lower your going to need a bigger box period.

@ Boomin_tahoe. I agree but I can see that some people need to learn some respect @JohnKuthe watch what you say, and you should learn some respect, let this be a warning we don't allow this type of stuff on this forum Or You Will Be Banned You say your not an expert yet your giving...

No it was screwed in place but if anybody else goes this roughy make sure you stretch that fabric tight or the fabric will be blown off of its fram SA 12-D4 x2 Old School PPI amps & 31 eq, Pioneer HU, Focal fronts, Mechman, 4/0 & 1/0 everywhere,Interstate batt x3 6cuft 28Hz

No it it defiantly did not Sent from my iPhone using Tapatalk

I'm just guessing but at 1400 rms and 2 SA12's in a walled civic. I would be surprised if I didn't break the 150 mark. I'm sure I did but I don't have a meter and I don't have the car anymore. Did all that on solid electrical , plenty of 14v juice SA 12-D4 x2 Old School PPI amps & 31 eq...