Ok so I bought an amp that's broken off of cl and it needs repair the amp goes straight into protection mode and there are some obvious issues and I tried to patch it up but dosent seem to want to leave protection mode all fets are fine but 2 capacitors on the board are swollen but still charge...
I'm stuck putting together this new system I sold my old set up and scorred enough cash to buy my new subs and encloshure I have 2 pioneer ts-w3002d4 subs in a atrend sub box its about 1.75 cu.ft per chamber seperated chambers and I have the box wired down to 1 ohm at the amp only problem is im...
ok i think that one was bull **** but still 150 Rockford Fosgate RFK1 1/0 Power Installation Kit: RFK1 Car Audio Closeout - Speakers, Subwoofers, Navigation, Car Audio, Video , Car Stereos, Amplifiers, Marine and more
no problem man u saed me AlOT of time and money haha i could have bough like 10 boxes and not found what i was looking for cosmeticly or performance wise but ur desigh was exactly what i wanted and needed i got a dual 12 ported box as u can see is my defalt with a horable port it only goes to...
rockford was all i could get beside kicker and i swear against kicker so i went rockford i hear hreat things about knu if u can get it go with it id say
im using 2 12s and there goin in a car a maxima i goin to put it in 3.2 cu.ft box tuned for 32 hz with the port to the left and the subs to the right and a shared chamber dodge desighs is making me the box desigh for me he has great work would recommend him to anyone who needs box desighs
i use a 4 gauge rockford fosgate kit i got 30 feet or so of 4 gauge wire 2 distributer blocks 40 feet of 16 gauge wire a maxi fuse holder and remote and 2 sets of very nice rca's for 150 thats good to me the rockford wire exceeds awg standards more strands then in the average wire and very...
ok i have 2 ts-w3002d2 subs andno idea what to use for a box i wana make one but dont kno if i should go ported or sealed and what to do for ether when i decide i want ported but dont kno if its the best way to go and if i need help making planes i dont want the box to be carpeted just painted...
na it sould really be ur ground wire if u did move it to a better sopt and u still got it maby ur amp is goin but that amp shouldent go if it was ur subs it would ether make a scratchy sound or would be stuck in or out or just plain not move whats happening witht them sticking is u have a signal...
thanks guys any cheap prefab boxes cause i have little money and time and can anyone explain clippin in detail i think im clipping because my subs get extreamly hot and my amp stays warm and i get a crispy sub coil smell out of my port that fills the car
i have no clue what to u se for a box its recomended box size dosent seem to let the sub play out all the freq. of a full bass line what should i use? also i am useing a
bamf5500 amp i am running it at 2ohms and the subs are getting really hot and giveing em a nasty smell at high volume it...
i have a dual poerted box with 1.6 cubic feet on each chamber (combined chambers no devider in the port) it hits great at higher bass but when it goes to low bass lines the sound almost goes out but the subs are really pushing a large excursion they get extreamly hot to after loud and long runs...