Recent content by xtremekustomz

$450 SHIPPED FOR ALL 3. Last chance. Will be taken down tomorrow.

$500

$550 for all shipped

Yeah I might be able to do a little better and yes I can get parts.

Sorry. Inbox is clear now. I will have to measure them. I'd say 5"-6" shorter

Dimensions (With Endcaps): 25-3/4" L x 10" W x 2-1/2" H

oops...just saw where we have to post a picture with the date on it. You can delete the listing here. I've already put them back in the closet and don't really care to drag them back out to take more pictures. I will continue to try my luck on craigslist.

Item(s) for Sale: (2) Kicker SX900.4 and (1) Kicker SX700.4 Item(s) Description/Condition: Good All 3 of these were bench tested back in October and worked flawlessly. One of the 900.4's has an endcap with a broken fin and missing a few endcap screws. The other 900.4 is missing a few endcap...

To get height you are probably going to need to put something up higher. A set of tweets may work. Just have to try and play around with it. Keep in mind that when you run multiple sets of drivers running at the same frequencies you aren't going to get a good stage because time arrivals are...

This tutorial was written by someone YEARS ago. I didn't read all the posts. Just skimmed through. This should help though instead of using time alignment. That is if you prefer. Try it out and see! "There are several different methods used to tune eqs. This is the one I use. An RTA is not...

So we got us a new toy at work. We've only had it hooked up for a little over a week. Or that's when we got our first training classes. I installed the engraving head on the machine and etched a piece of plexi for a guy I work with. I've found quite a few logos here: Brands of the World if...

I shot this video using our cnc router the other day at work. I never though mdf was this porous but the video kinda proves that it is. video0003 - YouTube

You can see the vacuum near the end of the video on the floor. It's pretty large. Not sure of the hp rating on it but it is 3 phase.

I'm going to take a 3/4" piece to work and see what it does. I was surprised it is able to create that much suction. I knew it was porous but not to the point of what it is. I'm not saying that most of you guys didn't know this. I know people have questioned the porosity of MDF and figured this...

I created this video at work of our CNC router table. It has a vacuum connected to it and a piece of 1/2" mdf is laid on top. When the video starts the vacuum is off and the paper glides across freely. The vacuum is then turned on and it creates a suction THROUGH the mdf and makes the paper...