12" Alpine Type R's cut out

I had this issue a few months back and t was a bad connection at the fuse block under the hood and it had actually started melting the wire and block at the bad connection.

 
^ i'd check this out.

also what does your ground look like? did you ground to the body of the car? did you scrape the paint off underneath the ground or is it grounded right on top of the paint?

 
All my connections are good. The ground is going straight to the frame. Everything is tight. It sounds a little cleaner when it plays but it still cuts out at the same spot. Do you think maybe the m110 amp is too much for the type r's =S I'm so confused on this stuff right now..Maybe the wire should be changed..?

 
ok guys freaking out now. I hooked up my old Alpine MRP M500. Works like a dream. Now what the f*ck can that be?! somethings gotta be wrong with my amp. what do you suppose that is? i bought it last week new.

 
send it back thru the warranty and get a new one or fixed however they do it till then just run one type r on the other amp you have thats your best bet

 
I think it's 8 gauge. Battery and ground.
There is your problem right there. Your amp is fused at the amp at 100 amps. You are not feeding the amp enough current. 8 gauge is fine for your 500 watt Alpine beause it only pulls 60 amps at full tilt boogie.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

The cutting it off part is what I'm confused about now. The speakers in my car have two wires coming off of them but I would only have one wire on...
2
576
The Type R subs are a really great sub. Deff ask about a DMM reading or take a DMM and check them. Dust Caps can be replaced as stated and...
7
804
FOR SALE Alpine PDX-V9
As the title states, I'm selling my Alpine PDX-V9. This is a 5-channel amp, with 500 watts being delivered to the sub channel (2-4 ohms) and 100...
0
592
Any indication that a loose wire may be the issue? I'd start by checking all the +/- connections to see if one has come lose or is starting to...
1
720

About this thread

Noob@Bass

Junior Member
Thread starter
Noob@Bass
Joined
Location
North Dakota
Start date
Participants
Who Replied
Replies
25
Views
4,451
Last reply date
Last reply from
The Audio Guy
445981256_3731324230470906_9081536917273579948_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0
445387485_1610561083127261_6762343569694877677_n.jpg

Decebal

    Jun 10, 2024
  • 0
  • 0

New threads

Top