Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Equipment
Amplifiers
2 Alpine R-SB10V on S-A60M?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="nealuss" data-source="post: 8868912" data-attributes="member: 690727"><p>Hello all, first time poster here. Title pretty much sums it up. Basically I currently have one Alpine R-SB10V (Halo series linkable prefab) on a S-A60M. The amp is rated for 600w @2ohm but the dyno sheet states it tested at 850w rms. I just bought a second R-SB10V I will be getting an R2-A150M (1500w rms suggested by alpine) when I can afford it, but that may be a couple of months. Should I go ahead and set up the second sub with the amp I have or just leave the 1 until I can get the right amp? Will it be better, worse, or about the same?</p></blockquote><p></p>
[QUOTE="nealuss, post: 8868912, member: 690727"] Hello all, first time poster here. Title pretty much sums it up. Basically I currently have one Alpine R-SB10V (Halo series linkable prefab) on a S-A60M. The amp is rated for 600w @2ohm but the dyno sheet states it tested at 850w rms. I just bought a second R-SB10V I will be getting an R2-A150M (1500w rms suggested by alpine) when I can afford it, but that may be a couple of months. Should I go ahead and set up the second sub with the amp I have or just leave the 1 until I can get the right amp? Will it be better, worse, or about the same? [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Equipment
Amplifiers
2 Alpine R-SB10V on S-A60M?
Top
Menu
Home
Refresh