Hey what's up been awhile since i've been around dont have another system installed yet and never had to do this, so my question is how to tell if an amp work's without bringing it to a store would this work, ground of amp to ground of batt, power of amp to power of batt fused of course and remote to power of batt fused anyway. let me know if this is ok and cannott cause any damage. Or if someone has a better idea thanks in advance for the help
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
- Started by Adam Spiekerman
- Subwoofers
You have a blown cap in the amp more than likely. Had the same thing happen to a soundstream amp.
- Started by Adam Spiekerman
- Subwoofers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
About this thread
New threads
-
-
FOR SALE 2/0 Royal Excelene21’ 2/0 Royal Excelene Wire (Red) 6’ 2/0 Royal Excelene Wire...
- Started by AnthonyO
- Replies: 0
-
FOR SALE BNIB: NVX XCAP10HProduct Details: NVX Digital 10 Farad Hybrid Capacitor (Cap)...
- Started by AnthonyO
- Replies: 0
-
diff problemHi everyone! Some months ago, my subwoofer started doing...- Started by Decebal
- Replies: 1
-
unwanted loud constant bass when i turn up my gain on my ampSubs play to the beat with gain low but if I turn it up my...
- Started by Adam Spiekerman
- Replies: 0