Amp distortion

  • 1
    Participant count
  • Participant list

orangecountyjd
10+ year member

Junior Member
Ive been searching on here trying to find an answer but i cant, I recently bought a mb quart onyx 1000d and when i turn the gain up (using a dmm) my type r makes an distorting noise, at a lower volume then my previous amp did wich was a sony explode that gave it 450 watts and was a class a/b,so i dont get why its doing this considering the mb quarrt is rated at 750watts at 2ohm and the sony is rated at 450watts why am i getting distortion earlier with a better amp ive checked voltages everywhere with my dmm never goes lower then 12.5 ive tried the amp on a different sub and in a different car and it still does it any ideas on what it could be?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
57
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
255
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
467

About this thread

orangecountyjd

10+ year member
Junior Member
Thread starter
orangecountyjd
Joined
Location
Orange County
Start date
Participants
Who Replied
Replies
1
Views
892
Last reply date
Last reply from
orangecountyjd
Screenshot_20240611-211145.png

Blackout67

    Jun 11, 2024
  • 0
  • 0
received_1404248310277849.jpeg

Blackout67

    Jun 10, 2024
  • 0
  • 0

New threads

Top