fuse

[jco1385 5,000+ posts]

idk if it's rated right or not, but 10ga wire is what i use for speaker wire. you need at LEAST 4ga.

here's the page from the manual:

LINK TO DOWNLOAD MANUAL

 

[loopkiller 10+ year member]

What voice coils are on your subs ad how are they wired to the amp?

Oh and BTW, RF does not make 10 awg power wire. //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

 

[jco1385 5,000+ posts]

RF does not make 10 awg power wire. //content.invisioncic.com/y282845/emoticons/fyi.gif.9f1f679348da7204ce960cfc74bca8e0.gif

are you sure??

 

[badguydotnet 10+ year member]

they do make 10 http://www.bestbuy.com/site/olspage.jsp;jsessionid=MVAGGZ1T2HZ11KC4D3FVAFQ?skuId=8286927&type=product&id=1172276905277 and not sure about the voice coil

 

[jco1385 5,000+ posts]

the subs are svc 4ohm. wired in parallel you get 2 ohms at the amp. how do you have them "bridged"?

you want + from one sub to + from the next connected to + at the amp. same with the -

 

[badguydotnet 10+ year member]

on the amp it says bridge so i assume that meant bridge when i put both + in the + on the amp and the did the - the same like i sayed im new

 

[jco1385 5,000+ posts]

on the amp, there are 2 pos, and 2 neg.

to bridge the amp, it'll be marked where you should put the pos and neg wires (only 1 wire each, pos/neg).

you want to hook the subs up like i said before, then from there to the amp. this will put the amp in bridged mode with a 2ohm load. you'll never run it at any real volume with a 10ga power lead, so you'll HAVE TO upgrade to at least a 4ga wire for pos and ground.

 

[loopkiller 10+ year member]

are you sure??

RF website

I just went to their site and they show 8, 4, and 1/0 power wire there //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[badguydotnet 10+ year member]

ok i gotcha so i wasnt bridging them i was doing some wierd **** but it did beat hader before the fuse blew

 

[jco1385 5,000+ posts]

this page says to use "#4 wire" aka 4ga

 

[jco1385 5,000+ posts]

and thats all i gotz. i posted a link to the manual a few posts up. i've already stayed too late //content.invisioncic.com/y282845/emoticons/crap.gif.7f4dd41e3e9b23fbd170a1ee6f65cecc.gif

 

[badguydotnet 10+ year member]

hey man i really appreciate the help u made it make since but ima go wit that let u kno the outcome and i got the manual