Help??

  • 1
    Participant count
  • Participant list

Trailblazers

CarAudio.com Newbie
3
0
I have an aftermarket stereo and I recently added an amp (JLAudio RD900/5) and sub (JL Audio HO112RG-W3v3). The installer set the gains, but the speakers are low in my opinion. Before I installed anything 18 was loud enough to listen to music. Now that I’ve added an amp and sub I need to at least put it on 19 or 20 to get good sound. The speakers aren’t loud enough and I have new components installed. The installer didn’t reset the equalizer on the head unit prior to setting the gains. Could it be I need to increase the input sensitivity or filter frequency?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Got it figured out! Thankfully a friend just found out about KunKonceptz UBT-20 terminal adapters that allow multiple connections to my type 94...
3
526
Turn the volume completely down and operate ot normally. This is to see if it is the built in amplifier that is shutting down. If the radio does...
1
429
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
12
550
I went with Kenwood Exelon. Audio Control amp and speakers. It’s amazing! I’m glad I did some research before buying. Thanks guys.
5
616

About this thread

Trailblazers

CarAudio.com Newbie
Thread starter
Trailblazers
Joined
Location
Start date
Participants
Who Replied
Replies
0
Views
467
Last reply date
Last reply from
Trailblazers
Screenshot_20240609-212906.png

Blackout67

    Jun 9, 2024
  • 0
  • 0
Screenshot_20240609-212805.png

Blackout67

    Jun 9, 2024
  • 0
  • 0

New threads

Top