barrolde
Junior Member
Hi Folks,
First of all i am more disapointed to be writing this than you are to be reading it //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif I've been reading and reading forums but am still a little unsure as to how to properly setup my old crummy hardware.
My hardware is:
Deck - Panasonic CQ-C1305U (rear RCA pre outs only)
Amp - Alpine V12 expert MRV-F405 (4 channel)
Door speakers - Alpine SPS-170A 200W max, 40W rms
tweeters - unknown sony (hidden under dash atm)
sub - not purchased yet but will probably be 1 or 2 modest 8" subs under my seat
2 x JL audio passive crossover boxes - have tweeter, woofer and input connections
My goals are very modest, just to have this crap hooked up right. Mainly my confusion is around the amp.. never used a 4 chan before.
So my deck only has rear pre-outs, i will use Y splitter to run these to chan's 1,2,3,4 inputs on my amp right?
From my amp, I will go out of channel 1 + and - to both crossover boxes and from them to the appropriate speakers right?
From my amp, I will go out of channel 2 + and - straight to my sub?
Will this work? Any better ways to do it? Any concise and logical advice would be appreciated //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif
Cheers!
Barry
First of all i am more disapointed to be writing this than you are to be reading it //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif I've been reading and reading forums but am still a little unsure as to how to properly setup my old crummy hardware.
My hardware is:
Deck - Panasonic CQ-C1305U (rear RCA pre outs only)
Amp - Alpine V12 expert MRV-F405 (4 channel)
Door speakers - Alpine SPS-170A 200W max, 40W rms
tweeters - unknown sony (hidden under dash atm)
sub - not purchased yet but will probably be 1 or 2 modest 8" subs under my seat
2 x JL audio passive crossover boxes - have tweeter, woofer and input connections
My goals are very modest, just to have this crap hooked up right. Mainly my confusion is around the amp.. never used a 4 chan before.
So my deck only has rear pre-outs, i will use Y splitter to run these to chan's 1,2,3,4 inputs on my amp right?
From my amp, I will go out of channel 1 + and - to both crossover boxes and from them to the appropriate speakers right?
From my amp, I will go out of channel 2 + and - straight to my sub?
Will this work? Any better ways to do it? Any concise and logical advice would be appreciated //content.invisioncic.com/y282845/emoticons/wink.gif.608e3ea05f1a9f98611af0861652f8fb.gif
Cheers!
Barry