New Amp

tdiddy
10+ year member

Member
I just bought a new Kenwood KAC-9103D 1800 Watt amp and hooked it up last night and at first it was going good then later that night my subs would shut off for a couple seconds and come right back on... then today my head unit would turn off then come right back on... any suggestions?

 
i have the 1700watt.. these things are power hungry as hell.. youre getting undervoltage (it kicks the amp into protect at like 12.4 volts or under) and the amps restarting.

im running a group 31 battery, Big 3 and 2 runs of 2 gauge welding wire and i cant bump a whole song without it doing this.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
115
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
321
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
456
  • Locked
NVX MVPA1 Best tiny amp Installed a bunch, but have one pushing a sealed 12 @ 2ohm in my daily beater Can bump it all day long and barely gets...
4
745
Amp
This tested well on youtube - not familiar with the brand but it is a pretty standard china build house amplifier...
5
542

About this thread

tdiddy

10+ year member
Member
Thread starter
tdiddy
Joined
Location
Arnold, PA
Start date
Participants
Who Replied
Replies
5
Views
415
Last reply date
Last reply from
XanderMoser
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top