Menu
Forum
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Car Audio Discussion
General Car Audio
Car Audio Build Logs
Car Audio Equipment
Subwoofers
Speakers
Amplifiers
Head Units
Car Audio Help
Wiring, Electrical and Installation
Enclosure Design & Construction
Car Audio Classifieds
Car Audio Classifieds
Car Audio Wanted
Classifieds Member Feedback
Gallery
New media
New comments
Search media
SHOP
Shop Head Units
Shop Amplifiers
Shop Speakers
Shop Subwoofers
Shop eBay Car Audio
Log in / Join
Test
Forum
Search
Search titles only
Search titles only
Log in / Join
Search
Search titles only
Search titles only
What's new
New posts
Live Activity
Search forums
Members
Registered members
Classifieds Member Feedback
Menu
Reply to thread
Forum
Car Audio Help
Wiring, Electrical & Installation
Trying to un**** the install done by previous owner
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Message
<blockquote data-quote="JDay" data-source="post: 8583054" data-attributes="member: 673282"><p>I have a 2001 Yukon XL 2500. When I got it the aftermarket system was not done right. I ran 12 gauge runs from the back, through the door grommets and used these for my door speakers, bypassing the factory speaker harness. Ripped out the 8 gauge CCA power and ground cables installed by the previous owner (the positive had a 15a fuse under the hood that was melted into an open circuit), that was powering a 500 watt amp. Ran new power, ground and RCA cables. Basically just tip everything out and start over.</p><p></p><p>Sent from my LG-H910 using Tapatalk</p></blockquote><p></p>
[QUOTE="JDay, post: 8583054, member: 673282"] I have a 2001 Yukon XL 2500. When I got it the aftermarket system was not done right. I ran 12 gauge runs from the back, through the door grommets and used these for my door speakers, bypassing the factory speaker harness. Ripped out the 8 gauge CCA power and ground cables installed by the previous owner (the positive had a 15a fuse under the hood that was melted into an open circuit), that was powering a 500 watt amp. Ran new power, ground and RCA cables. Basically just tip everything out and start over. Sent from my LG-H910 using Tapatalk [/QUOTE]
Insert quotes…
Verification
Post reply
Forum
Car Audio Help
Wiring, Electrical & Installation
Trying to un**** the install done by previous owner
Top
Menu
Home
Refresh