Imperiumwolf
CarAudio.com Newbie
I had numerous stereo systems in high school in the mid to late 90's but have been out of the scene since around 2000 or so. A few years ago I got a new truck (2016 Ram 1500 Quad Cab) and decided that I wanted to tinker around with car audio again.
This past week I installed a dual 2 ohm 10" Kicker Comp R in a FoxBox with a Kicker 46CXA400.1T. I'm using the factory head unit with a PAC t-harness and a Kicker Kisloc2.
I have bass now but it is extremely underwhelming. Honestly, it doesn't seem much louder than the Bose system in my wife's Nissan Murano. I realize this is an entry level subwoofer, but I've ran numerous budget subs in the past, on less power, and they all had much more volume and played deeper.
I'm not sure where I went wrong. I am positive I wired it correctly to 1 ohm. I tried setting the gains with my multimeter but I can't seem to get any readings that make sense (they constantly jump all over the place; it's also reading the sub at 0 ohms despite the sub working). It's a cheap GE multimeter and I plan on getting a better one this weekend. So right now I have the gain set just above the lowest setting.
I was so excited to have some bass again and now I'm wondering if I should have even bothered with it. Am I just expecting too much from a $100 sub?
This past week I installed a dual 2 ohm 10" Kicker Comp R in a FoxBox with a Kicker 46CXA400.1T. I'm using the factory head unit with a PAC t-harness and a Kicker Kisloc2.
I have bass now but it is extremely underwhelming. Honestly, it doesn't seem much louder than the Bose system in my wife's Nissan Murano. I realize this is an entry level subwoofer, but I've ran numerous budget subs in the past, on less power, and they all had much more volume and played deeper.
I'm not sure where I went wrong. I am positive I wired it correctly to 1 ohm. I tried setting the gains with my multimeter but I can't seem to get any readings that make sense (they constantly jump all over the place; it's also reading the sub at 0 ohms despite the sub working). It's a cheap GE multimeter and I plan on getting a better one this weekend. So right now I have the gain set just above the lowest setting.
I was so excited to have some bass again and now I'm wondering if I should have even bothered with it. Am I just expecting too much from a $100 sub?