Recent content by ChillyWilly72

I like the mic and rta app idea though.

I think I have it now but not 100%...I have dash 3.5s to ch1 of the LC7i, rears to channel 2 & summed, and fronts to ch3 & summed so fronts get a now complet signal (still not 100% all vocals are coming through though) and giving bass signal for the sub.

Does anyone know or can you measure (pretty please with strippers on top) what frequencies are going to each speaker location? I have the 30 pin harness from autoharnesshouse with High level signals pulled from the dash, front & rear doors and subwoofer (4 total). I am running 3 of those to an...

I even cut up an RCA cable and soldered it to an extra set of DMM leads I had laying around so that it would be easy peasy.

I am measuring from the LC7i...HK system in the WRX goes left & right full range to HK amp which then splits the signal for each speaker location. I had to sum these to get quality full range sound to amplify which is what the LC7i was used for but when I go to measure the signal so that I am...

As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded good (wish I had a O scope or a stereo shop near me to test but went by ear)

Thanks Dox, that is what I did and it seems to be working great (no red light from Starlink)

Ahhh...one other issue...I gotta figure out which wire on the harness I can use as a remote turn on as with the HK system doing things other than just audio my amps turn on early and are left turned on until the system goes to sleep)

I guess I can only Edit once as I was gonna show the new components of my system so here goes replaced the LC2i with an LC7i (Had the LC7i otherwise I would have bought the LC7i Pro) replace the 3 Ohm Infinity 3.5s with 4 Ohm 3.5s put in Infinity 6.5s in the rear doors Added an Alpine amp I had...

Your 100% correct, my car interior has been pulled apart and the passenger seat out for a month at least...but with the autoharnesshouse.com harness I pulled all three signals (HK in a Subi has two inputs to the HK amp which then splits the signal for each speaker location) coming OUT of the HK...

I select V~ and using auto it shows mV and when I select the range it shows nothing readable like a normal voltage 1.0-8.5 out of the LC7i.

yup, had my volume at 28 out of 38

Even tried a second dmm

Yup

I am trying to set gains on my lc7i but all i am getting is mV readings with 2 dmm...tried auto mode and selecting modes, what am i doing wrong?