Recent content by Metalbob

Will do thanks!

Bought the 270 amp alternator

Considering one as well, did you end up purchasing from them? thanks

Anyone use any of their HO alternators? Considering getting one from them since they are somewhat local to me in socal. Been awhile since I've logged in here . Good to be back at it. Thanks

i see where youre getting at. i dont even know what a dsp is and i get it.

hi all, can S/O cord be utilized for power and ground connections or the big 3. like the larger sizes? some of just curious? thanks Metalbob

been following all the posts and must say, its been entertaining and there have been lots of WTF? posts. is there anything he hasnt done?

Hey all Would a tline work in a 2005 4 runner? Rear space allowable is 41.5 across x38 deep. Im looking at using either a 10 or 12 with 2k rms to start, with potential go up to 4k rms Im aware of the large size, electrical etc.. Im used to my current setup and Want more. Or just go with a...

Whats the purpose of the pass thru then? I thought maybe to get another prime 750. But if it cannot be strapped ill have to look at buying a different amplifier(s) Im just exploring options for the new set up vs possibilities with what i have. And im definitely down for a demo. Im just not...

Is this the same as strapping ? If i get another prime 750 is this what i would use? Sorry for the nooboob question. If this is possible, could the strapped amps power a single sub like an sq hdc 3112? Im on the quest for more bass. Thanks guys! Metalbob

Heres the specs from rf for the enclosure, i thought the enclosure looked smallish? PL3-210 (Dual 10" DVC) Nominal Impedance (Ohms) Power Handling (Watts-RMS/Peak) Internal BoxVolume (ft3/liter) Overall Dimensions (HxWxD) (cm) 4 (8x2) 800 / 1600 2.10 (59.46L) 13.5” x 31.25” x 16” (34.3 x...

I have 2 dvc 400 rms 10" rf subs. Im looking at getting more power and larger/ higher rated subs. How much more can i go than the total 800 rms safely? Would it be able handle 1200 rms?Im looking to as high as 2000 watts rms in the very near future . I'd like to go 12 in or possibly 15 in subs...

I wired it to 1 ohm. Today enjoyed it briefly Hits much harder

I ended up with the rf prime 750 ,didnt want to do any electrical upgrades so i think this will suffice For now...

Hi all, Im a little confused on which amp to get for the RF enclosure i have , its a pl3210 dvc 800 rms I have been checking out the following amplifiers RF prime750 - i would run this at 1 ohm to get the most from this amp Hifonics Brx 24001d- i would run this at 4 ohm to get the 800rms...