If a sub's voicecoil fails, it will usually drop impedance causing too much current to go back to the amplifier. The amplifier then protects itself by shutting down playback.q
Activity
No one is currently typing a reply...
Similar threads
Using a Y RCA to split signal from amp to amp to give both amps the signal they need from the HU and subs in different /separate enclosures tuned...
- Started by Aaron Johnson
- General Car Audio
Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
- Started by esb
- Wiring, Electrical & Installation
Have you checked the fuse block. With time, tight connections can loosen and cause failure. Refresh those contact points and test again. Remember...
- Started by Ruizbra
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
- Started by William Melcic
- General Car Audio
About this thread
- Start date
- Participants
- Who Replied
- Replies
- 15
- Views
- 1,883
- Last reply date
- Last reply from
- 1aespinoza
New threads
-
Low volume ONLY while drivingI have a Skar svr-10 inch sub and a skar rp-800.1d 800w rms...
- Started by Maddoxp07
- Replies: 0
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 4
-
-
Multi speakersHello all, need some wiring advise for some speakers. I have...- Started by 07FLSTC
- Replies: 2