AudioControl question

  • 3
    Participant count
  • Participant list

sstumpf

Senior VIP Member
I am wanting to put a single 10" and upgraded front components in my 11 silverado. But keep the factory HU. Using a 5 channel amp.

Question is, can I get away with using the lc2i tapping into the factory rear speaker wires for my full range signal. Then using the main output on the lc2i for the front component set and use the bass output for the sub channel? Sound like it should work, just wanted to make sure.

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Fully test it without the ACR-1. TBH it sounds like an amplifier issue. Try connecting your phone direct to the amp via a 3.5mm to RCA cable. If...
2
697
Good thing its under warranty and that you have contacted A.Control about the issue so it has been documented. It will help speed up the return...
6
1K
Looks like half a dozen other makes/models on the market, rebranded . The shallow mounts look like they’re made by Pioneer but what the hay, one...
8
1K
Go to DIYMA some people there are willing to remote tune it for you for a small fee. Usually around 30-50 dollars.
1
1K

About this thread

sstumpf

Senior VIP Member
Thread starter
sstumpf
Joined
Location
Fisher, IL
Start date
Participants
Who Replied
Replies
5
Views
683
Last reply date
Last reply from
sstumpf
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top