Blown sub?

DHawk86

Junior Member
So I was driving today when my sub just cutout and wouldn't come back on. It wasn't that loud compared to volumes I've run the sub at before, and I had only been driving for about 10 minutes when it cutout.

Anyways, I went through the standard troubleshooting: Checked fuses at the amp and battery (they were fine), checked RCA's by connecting Ipod with Y-cable to amp (still nothing), then measured AC voltage on speaker outputs from amp (voltage modulated up and down when I adjusted volume). Now I'm checking the resistance of the sub (Memphis M3 10" DVC 2-Ohm). I'm getting 2.0 to 2.1 Ohm on one coil. The other coil is giving me values of about 200 kOhm to infinite resistance. So I'm guessing the sub is blown correct? The sub is still under warranty, I just want to make sure its the sub and not my amp before I bring it back.

 
So I was driving today when my sub just cutout and wouldn't come back on. It wasn't that loud compared to volumes I've run the sub at before, and I had only been driving for about 10 minutes when it cutout.
Anyways, I went through the standard troubleshooting: Checked fuses at the amp and battery (they were fine), checked RCA's by connecting Ipod with Y-cable to amp (still nothing), then measured AC voltage on speaker outputs from amp (voltage modulated up and down when I adjusted volume). Now I'm checking the resistance of the sub (Memphis M3 10" DVC 2-Ohm). I'm getting 2.0 to 2.1 Ohm on one coil. The other coil is giving me values of about 200 kOhm to infinite resistance. So I'm guessing the sub is blown correct? The sub is still under warranty, I just want to make sure its the sub and not my amp before I bring it back.
you lost a coil file a warranty claim and hope they dont try and screw you

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Everyone I found the problem it's the RCA cables, I had my electrician mate have a look and he pulled one of the cords halfway out and the subs...
14
1K
What amp and Ohm load are you running? What are the dimensions of the enclosure? sealed or ported?Tuned too? You may be better off buying a pair...
2
992
  • Locked
I have a zapco 4.0 and 6.0 that was stored in an area near the beach and corroded it pretty bad. Never was powered since it was stored working...
14
5K

About this thread

DHawk86

Junior Member
Thread starter
DHawk86
Joined
Location
Seattle, WA
Start date
Participants
Who Replied
Replies
4
Views
589
Last reply date
Last reply from
93dakota
Screenshot_20240609-212906.png

Blackout67

    Jun 9, 2024
  • 0
  • 0
Screenshot_20240609-212805.png

Blackout67

    Jun 9, 2024
  • 0
  • 0

New threads

Top