Thanks guys, I will be hopefully wrapping it up this week cuz its gunna snow... Still need to finish running the wires, Get the pods for the tweets made, Tweets/mids mounted, and door panels cut to fit for the new mids... Kinda slacked off lately lol
Havent been around a laptop for awhile so I am trying to get pics up... Here is some quick shots of all the wires Techflexed up...
I ran the remote wire inside the wrapping with my 2ch RCA's to keep it hidden and use the wire pants to keep the same look... Ill get better pics of this later since its looks very clean IMO...
Getting the wires ran, RCA's down the middle and mid/tweet wires down each side... Also laid down that IXOS deadener just cuz... Used Gorilla tape to keep them in line which worked well
Before shots while it was still light... The Deadener is already laid down here (Black rubber looking mat)
After, sorry they are hard to see... RCA's ran underneath the E brake panel... The speaker wires for the passenger side are ran in holes along the side (Red circles)
You saw the wires come into the cab from the doors through the holes that I had to drill... from there they run down each side in stock cut holes (red circles up above) and then under the rear seat to meet up with the RCA's where the extra will be spooled up...
Here is the mess where they all meet which I had to organize under the rear seat before it went back in...
Hahaha luckily everything is going to clear the table perfectly but I may do something to it... I did just get a little vice though I wonder if I could do something with that? I was gunna do a power inverter for when I do work out of my car...