Box Build for SVTLightning01

I couldnt do that to a lightning. I figured someone else who could afford it would drive it as it was meant to be.

400whp/495tq sure was fun though. 10mpg wasnt. $104 for 270-300 miles hurts the pocket as much as i drive to vegas to see the folks.

 
you doing a e85 conversion?
I dont know much about it, but its a new technology that i wont gamble a 8k motor on something that isnt proven.

Good luck to you though!
I researched e85 and it actually hurts your gas mileage! its just some stupid go green ****.

What Im doing has been tested plenty of times but people keep getting payed off to keep it a secret. Im going to run my truck half off hydrogen half gas. I will be making the hydrogen under the hood by running electricity through water with stainless steel cells. the hydrogen will get ****** in through the intake and it is 2 times as powerful as gas. The truck will sense the change and adapt.

 
I couldnt do that to a lightning. I figured someone else who could afford it would drive it as it was meant to be.
400whp/495tq sure was fun though. 10mpg wasnt. $104 for 270-300 miles hurts the pocket as much as i drive to vegas to see the folks.
yup its expensive to drive this babies now indays:D filled mine up few days ago and it was around 95 bucks:(

 
yup its expensive to drive this babies now indays:D filled mine up few days ago and it was around 95 bucks:(
Probably another downer was moving from VA to CA. Had to retune for 91 octane, and lost about 20whp. On top of that, we were pretty active in a ford lightning club (about 40 trucks).

Out where i live there isnt too many.

Where you live SVT?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
The tricky bit is that they're soft and floppy and they may be stretched a tad to go over the frames. I've used them in the past and come out...
6
2K
In order to answer your question, I would need to know what model (e.g. SW4200, SW7524DVC). Also, are you looking to make a ported box or sealed?
3
2K
Thanks everyone for the feedback. I got scared of the 4th being to much for a newbie but did end up building a box to 2.1 Cubic Foot tuned to...
7
2K
Love this sub, hate AB's site, short on info for sure. American Bass XR-10D2 box recomend: If you want to tune a 2.75 Cu Ft box (for two of these...
11
3K

About this thread

bjfish11

5,000+ posts
FisherCustoms.com
Thread starter
bjfish11
Joined
Location
Garden Plain, KS
Start date
Participants
Who Replied
Replies
31
Views
4,246
Last reply date
Last reply from
SVTLightning01
Screenshot_20240518-030709~2.png

1aespinoza

    May 18, 2024
  • 0
  • 0
1000007975.jpg

Mr FaceCaser

    May 16, 2024
  • 0
  • 0

New threads

Top