New Speaker Setup

[eleceng20]

How do I go about connecting all 6 of my speakers to an amp while getting the best out of the speakers?

Specs for Speakers:

4 - 6.5 inch JBL GTO638 3-Way Coaxial Speakers (in the doors)

2 - 6x9 Infinity Kappa 693.9i 3-Way Coaxial Speakers (in the rear deck)

6 total speakers

JBL GTOs

Nominal Impedance2 ohms

Sensitivity(2.83V@1m) 92dB

Power Handling (RMS)60W

Frequency Response50Hz – 21kHz

Power Handling (Peak)180W

Infinity Kappas

Sensitivity 95.6 dB at 2.83 volts

Frequency Response 35 - 30k Hz

RMS Power Range (Watts) 2-110

Peak Power Handling (Watts) 330

Impedance (Ohms) 4

Top-mount Depth (Inches) 3 5/16

Bottom-mount Depth (Inches) 3 7/8

Will be adding a mono amp later for a sub.

Click to read more...

 

[garychoffmann 10+ year member]

With 2 ohm speakers and their placements i would use a 6 channel or a 4 channel and a 2 channel. Or spend the coin on a high end 4 channel that is 1 ohm stable

 

[eleceng20]

I ended up purchasing the Clarion XC6610 1000W Max 6-Channel Marine XC Series Car Power Amplifier/Amp. It is rated to run 6 channels at 125w rms. Also bought a 3 farad capacitor.

 

[LosIsATool 5,000+ posts]

You don't listen much. Good luck