I have a thunder 9500 12" dual 4 ohm sub. I'm new to this, so any help will be appreciated....I need to build a sub box, something basic, probably a sealed box. I'm not sure how to go about it, dimensions, material, etc.... maybe a diagram of how to build it etc...I'm just looking for a clear, crisp, deep base....Thanks in advanced!
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Thanks buddy!
Given me a lot to think about in terms of what to do; I've been watching YouTube videos on this stuff all day as well so I really...
- Started by Jodhvir Minhas
- Amplifiers
This is what you need-
- Started by cdreece
- Wiring, Electrical & Installation
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
- Started by chris123
- General Car Audio
That would be a function of the harness, not the HU, I think. Have you looked into a Maestro or iData interface? i would check with crutchfield...
- Started by SamuraiRob
- Wiring, Electrical & Installation
Ahem, just a little something before you leave...
- Started by Maddoxp07
- General Car Audio
About this thread
New threads
-
Help with adding an aftermarket amp /speakers/sub 2019 EquinoxI have a 2019 Equinox (non Bose)(RPO code IOU)i want to keep...
- Started by cdreece
- Replies: 1
-
Low volume ONLY while drivingI have a Skar svr-10 inch sub and a skar rp-800.1d 800w rms...
- Started by Maddoxp07
- Replies: 1
-
WANTED Down4Sound MM1004 GrayWould like a gray D4S MM1004 to match my other gray MM1004...
- Started by kenvicta
- Replies: 0
-
What's this worth?Going to go on a different direction when I get my new...- Started by chillin
- Replies: 4
-