What kind of amp to get?

  • 4
    Participant count
  • Participant list
The door speakers I want are 4 ohms with 45 watt rms and 135 peak. And the sub is also 4 ohms with 250 watt rms and 1000 peak. But the rear deck is 2 ohms at 200 rms and 600 peak. What kind of amp

can I get so the ohms match up? Or do I need to get 2 separate amps? Maybe a 3 channel for the door speakers and sub and then a 2 channel for the rear deck?

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Rings? I've had to make them before because the factory speaker mount was plastic, and I've had to make them so the windows would clear the...
11
1K
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
208
No need to bypass the amp. Most use an LOC that takes the full amped signal and turns it into a flat RCA level signal. Here is the newest I have...
2
412
It would also be easy to add an equalizer to have individual rca inputs for all of the channels. A decent one can be had for less than $40...
6
493

About this thread

JScullari

Junior Member
Thread starter
JScullari
Joined
Location
New York, New York
Start date
Participants
Who Replied
Replies
4
Views
1,126
Last reply date
Last reply from
garychoffmann
20240604_170857.jpg

metalheadjoe

    Jun 5, 2024
  • 0
  • 0
Screenshot_20240605_200209_Adobe Acrobat.jpg

Dylan27

    Jun 5, 2024
  • 0
  • 0

New threads

Top