NFrazier 10+ year member
Senior VIP Member
Products that are being installed:
Mounted the fuse holder to the factory battery bracket. The power wire was loomed and heat shrunk to be as stealth as possible.
Next I ran all of the wiring following factory harnesses on each side. The wires were zip-tied approximately every 6". The power wire was ran through a gromnet I installed where the factory clutch would normally be.
Mounted the fuse holder to the factory battery bracket. The power wire was loomed and heat shrunk to be as stealth as possible.
Next I ran all of the wiring following factory harnesses on each side. The wires were zip-tied approximately every 6". The power wire was ran through a gromnet I installed where the factory clutch would normally be.