I swapped out a water-damaged amp from a '73 Mercury Cougar and wired four speakers (2 frnt Door/2 rear door panel) as shown here, but did not end up installing the Sub-woofer. The way the speakers are shown gives Balance but no FADER response. Should the speaker all now be separated into their own channel? Can someone please post a best wiring solution? CustomAutosound USA-230 Head Unit, Cerwin-Vega Mobile H7653 HED Series 3-Way Coaxial Speakers (6.5", 340 Watts max); TS400X4 Taramps Amp.
-
1Participant count
-
Participant list
Activity
No one is currently typing a reply...
Similar threads
Dammned good speakers. Just pass up the CL series,and you will be pleased with CDT speakers. I still enjoy all mine. Polk MM series and Infinity...
- Started by Kanewpadle
- Speakers
Yes. Only thing is the leads will be encased in resin.
Keep in mind that this is an assumption.
- Started by 1slow77
- General Car Audio
I agree with every one above. OFC is much better. Copper is a much better conductor than aluminum.
- Started by kanihoncho
- Wiring, Electrical & Installation
Speaker ratings are generally a thermal/mechanical limitation of the drivers. Music is dynamic, not continuous. During quiet periods a song, you...
- Started by kanihoncho
- Speakers
Thanks again have a good weekend . . . .
- Started by kanihoncho
- Speakers
About this thread
