Amp suggestion for a pair of JL 13w7's?

  • 4
    Participant count
  • Participant list

urnvs
10+ year member

Junior Member
I have a pair of 13W7's running off a bridged Kicker KX2500.1 and it is cutting out when the really low stuff hits. Im looking for a suggestion for an efficient amp(s) to replace this one, that will really push these speakers to the limit.

 
So your prolly running the amp at 1.5 ohms I'd guess which shouldn't be an issue for the kicker. So either there is an electrical issue here or a bad amp But if the amp plays fine except when that heavy bass note hits. I'd more likely think it's a power issue. What alt and what batts ?

 
Yes, 1.5 ohms which is actually lower than the 2 ohms Kicker recommends. Mechman alternator and Deka AGM batteries.

Dont get me wrong, it hits loud as hell before cutting out, but I just feel that there is still more room to go as its not really sounding distorted.

 
Yes, 1.5 ohms which is actually lower than the 2 ohms Kicker recommends. Mechman alternator and Deka AGM batteries.
Dont get me wrong, it hits loud as hell before cutting out, but I just feel that there is still more room to go as its not really sounding distorted.
Check voltage at the amp when it cuts out. Also check for loose connections in all the wires. It maybe something real simple Rule out all possibilities before you replace the amp

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

Great bang for the Buck/ Have (2)2ks and a 150.4. great amps for the Coin Thus far.A little head room doesnt usually hurt...
5
2K
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
17
Subs play to the beat with gain low but if I turn it up my subs play loud unwanted never ending bass that is constant and wont stop until I turn...
0
16
Getting a good voltage reading does not mean good power transfer. You could read 13.8v out of a 24 AWG wire. Recheck your amplifier's ground and...
2
222

About this thread

urnvs

10+ year member
Junior Member
Thread starter
urnvs
Joined
Location
Phoenix, AZ
Start date
Participants
Who Replied
Replies
8
Views
745
Last reply date
Last reply from
bumpasauras
Screenshot_20240609-212906.png

Blackout67

    Jun 9, 2024
  • 0
  • 0
Screenshot_20240609-212805.png

Blackout67

    Jun 9, 2024
  • 0
  • 0

New threads

Top