SOLD ***F/S A few things that need to go amps, subs, speakers, PAC, etc. F/S***

oxsign
5,000+ posts

No Affiliation
6,046
34
Orlando, FL
First I have a pair of Infinity Reference 3 way 6x9's $60 shipped to the lower 48. Sorry for the dust. They were in my blazer for 1 full day till I sold it.

IMG_0913.jpg


IMG_0910.jpg


IMG_0915.jpg


Next up is a pair of Polk Audio 4x6 plates BNIB never installed or taken out of the packages. MMC460 $60 shipped to the lower 48.

IMG_0917.jpg


IMG_0918.jpg


Next is a PAC SWI-PS. This alows you to use you factory steering controls with an after market deck. This is used for a Pioneer and/or Sony decks only. $20 shipped to the lower 48.

IMG_0921.jpg


IMG_0922.jpg


Next up

Kenwood KAC-628 Car Audio Amplifier. It's a little beat up, but works flawlessy. $40 shipped to the lower 48.

IMG_0928.jpg


IMG_0929.jpg


IMG_0930.jpg


Key Features

Amplifier Type Dual Channel

Bridgable Bridgable

RMS Power at 4 Ohms 50 W x 2

RMS Power at 2 Ohms 75 W x 2

Performance

Frequency Response 10 Hz - 45000 Hz

Signal to Noise Ratio 100 dB

THD at Rated RMS Power 0.08 %

Other Features

Input Voltage 14.4 volt

MOSFET Circuitry Yes

3 Way Ready Yes

Dimensions

Width 8.69 in.

Depth 9 in.

Height 2.19 in.

 
Next is a Power Acoustik PS4-240 4ch amp. $40 shipped to the lower 48.

IMG_0923.jpg


IMG_0924.jpg


IMG_0927.jpg


240 watt 4 channel car amp

45 x 4 @ 2 ohms RMS rated with true world ratings

Full MOSFET power supply

PWM circuitry

Selectable crossover (High/Full/Low)

Short , thermal, and overload protection

tri-mode capable

2 ohm stable stereo

Variable low pass: 40 Hz–120 Hz

Variable high pass: 150 Hz–1.5 kHz

18 dB bass boost @ 40 Hz

Freq resp: 10 Hz–30 kHz

S/N Ratio: 97 db

THD: 0.02%

System Distress indicator

High/low level inputswith floating ground

4-gauge power/ground connection

Gold-plated RCA connectors

Line output

4? RMS: 35 x 4

Dim: 9"H x 7"W x 2"D

Next is a pair of old school Kenwood KFC-W2502 10"subs. These things are rough, but work & sound great. One has a small hole in it (**** drill), but it does not effect the performance or sound. $30 for the pair shipped to the lower 48.

IMG_0933.jpg


IMG_0934.jpg


IMG_0932.jpg


IMG_0931.jpg


Next is a pair of SQ batt. terminals. Never used or connected/mounted. They will accept a 1/0, 4awg, & 2 8awg connections. $10 shipped to the lower 48.

IMG_0916.jpg


And last I have a brand new never used wire harness for a Sony CDXF7700. $5 shipped to the lower 48. Pix of that will be up later.

All prices are O.B.O., so let me know what you want, and what your offer is by PM's, or post here. //content.invisioncic.com/y282845/emoticons/fro.gif.c695f1f814b01c4ad99fe7f8cccadd29.gif

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think he'sasking because electricity is often compared to water to make it easier to understand. It can be helpful, but it can be misleading...
8
1K
The bigger the gauge number, the smaller the wire. 8awg would be smaller than 7awg. Yeah, go with 4awg. 7awg sounds like it must be for an...
7
2K
I found this, can it be done with snapon modis ultra scanner which i have...
11
1K
You can't really set it to a specific wattage. What head unit do you have? Find out the pre-amp RCA voltage. Most amp gain knobs are based off of...
7
1K
I also just checked the voltage and the voltage on the amp in 12.85 and the rest of my stuff like my lc2i and remote out wire is 12.10. could that...
6
75

About this thread

oxsign

5,000+ posts
No Affiliation
Thread starter
oxsign
Joined
Location
Orlando, FL
Start date
Participants
Who Replied
Replies
34
Views
1,994
Last reply date
Last reply from
brchd
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top