Kielthalin
CarAudio.com Newbie
Just curious if I got everything I need for an install. This is just a daily driver vehicle, a small sedan. Just looking for suggestions.
2x Skar Audio SDR-12 Dual 2ohm (600Wrms each) - Final Impedance = 2 ohm (series/parallel) in a 2.5 ft^3 Sealed enclosure (each sub in separate 1.25 chamber). Wired using 8AWG speaker wire to the amp. Might have to use 12AWG from the speaker box terminals to the amp if the 8AWG won't fit. I think I had that problem last time I used the amp.
Rockville DB15 amp - 2ohm rating is 1500W. I think these only dyno to around 1200W? This amp is from another setup. I have 1/0 OFC in a 17' run. The amp has a 150A fuse and I will be clamping to see the draw once setup. Curious if I will need another run of 1/0.
The alternator is stock, rated to 120A. Big three completed /w 1/0 bare copper cables (welding wire).
If the electrical give me issues (lights dimming etc.), other than running another 1/0 cable to the amp, what else could I do?
2x Skar Audio SDR-12 Dual 2ohm (600Wrms each) - Final Impedance = 2 ohm (series/parallel) in a 2.5 ft^3 Sealed enclosure (each sub in separate 1.25 chamber). Wired using 8AWG speaker wire to the amp. Might have to use 12AWG from the speaker box terminals to the amp if the 8AWG won't fit. I think I had that problem last time I used the amp.
Rockville DB15 amp - 2ohm rating is 1500W. I think these only dyno to around 1200W? This amp is from another setup. I have 1/0 OFC in a 17' run. The amp has a 150A fuse and I will be clamping to see the draw once setup. Curious if I will need another run of 1/0.
The alternator is stock, rated to 120A. Big three completed /w 1/0 bare copper cables (welding wire).
If the electrical give me issues (lights dimming etc.), other than running another 1/0 cable to the amp, what else could I do?