please please help im stumped

TRAP$TAR
10+ year member

breakin glass
30
0
stc
ok so i have a 1200 mono hifonics amp 4gauge wire kicker rca cables pioneer hu and 4 kicker comp cvr 10's

gain set to about a little past mid way and bass eq is set all the way down and my subs will hit but as soon as they hit a certian point the will start to distort just sound so ugly i tried a different hu re grounded everything checked all fuses nothing but yet the amp worked fine in another car on another sub with gains set very low i dont understand i cant get them to hit like the use too please help

 
I think you need to check gains my man. I think you have it a bit too high to be honest.

EDIT: in short, if you turn your head unit to as loud as you turn it daily and set your gains you shouldnt set it to where your subs distort.

It could also be the subsonic or lowpass filter if you dont know what those do.

 
which way they are facing, what was your old car, whats the new one?
there facing toward the cab in a 1986 oldsmobile cutlass supreme same as caprice and i just hooked the sub wires to a differnt amp in a differnt car

 
they might be wired out of phase, also try turning them around and see what its like, you might have to do some rear deck mods or take the back speakers out to let the bass wave in

 
I think you need to check gains my man. I think you have it a bit too high to be honest.
EDIT: in short, if you turn your head unit to as loud as you turn it daily and set your gains you shouldnt set it to where your subs distort.

It could also be the subsonic or lowpass filter if you dont know what those do.
no my gains set to about mid way the problem occurs when the gain is past mid way or when i turn the hu up even with all loud settings off .... when i re wired everything it the subs worked fine beating it down for about 5 minutes then started distoring again so i had to turn the gain back up

 
they might be wired out of phase, also try turning them around and see what its like, you might have to do some rear deck mods or take the back speakers out to let the bass wave in
thats a good idea cause i swear when i was pulling the box towards me and away from the cab they would start to hit then distort again when i moved them back

 
Activity
No one is currently typing a reply...
Old Thread: Please note, there have been no replies in this thread for over 3 years!
Content in this thread may no longer be relevant.
Perhaps it would be better to start a new thread instead.

Similar threads

I think you're gonna have to get good with fiberglass or something, or find someone with a 3d laser scanner that can 3d print or mold you some...
7
1K
Is this a blue or blue/white wire from the Kenwood? The ACC wire is red and although that should turn on the amp, it is not the prefered wiring...
1
756
The sound deadening is going to be more about preventing vibration from metal surfaces and adding unwanted noise. Does it have the JBL system...
1
740
It's called the K.I.S.S. preciniple ("Keep it simple, stupid!")... Takes the guesswork out of parallel/series wiring.
2
956
As for which signal to use, I tried all combinations and getting signal from the dash and front & rear doors is the only way the system sounded...
15
2K

About this thread

TRAP$TAR

10+ year member
breakin glass
Thread starter
TRAP$TAR
Joined
Location
stc
Start date
Participants
Who Replied
Replies
16
Views
854
Last reply date
Last reply from
TRAP$TAR
20240518_170822.jpg

Dylan27

    May 18, 2024
  • 0
  • 0
20240517_190901.jpg

Dylan27

    May 18, 2024
  • 0
  • 0

New threads

Top