MonteCarlo-Dice
Junior Member
I have a KenWood kdc - x891 head unit with three sets of preamp outputs (front, rear, sub).
I want to power these 6x9's with a concept cc-1252 amp
Concept Amp Specs:
RMS Power 125W x 2 4 Ohm
Signal-to-noise ratio: 100 dB
Frequency Response: 5Hz - 50kHz
18dB per octave crossover
Input sensitivity: 200mV - 4V
Im already powering my Memphis M3 subs with a Memphis 1000d.
My question is can I power my 3.5 speakers with the head unit as my front speakers and my 5.25 speakers with the head unit as my rear speakers and still use the rear pre amp output from my head unit to the concept amp to power my Polk db691's??? And will the concept amp blow my Polk db691's?
I want to power these 6x9's with a concept cc-1252 amp
Concept Amp Specs:
RMS Power 125W x 2 4 Ohm
Signal-to-noise ratio: 100 dB
Frequency Response: 5Hz - 50kHz
18dB per octave crossover
Input sensitivity: 200mV - 4V
Im already powering my Memphis M3 subs with a Memphis 1000d.
My question is can I power my 3.5 speakers with the head unit as my front speakers and my 5.25 speakers with the head unit as my rear speakers and still use the rear pre amp output from my head unit to the concept amp to power my Polk db691's??? And will the concept amp blow my Polk db691's?